This guide walks you through your first test print, from nozzle check to a finished transfer. Complete these before starting: Pre-operation Preparation, Install ZRIP and connect, and device setup.
- Open ZRIP and make sure the printer is connected (green icon in the lower-left corner of Settings).
- Click Nozzle Check to print a test strip.
- Inspect the strip: proceed only if there is no blurring, no ink splatters, and no missing lines.
If the strip shows missing lines or blurring, run the cleaning cycle once and repeat the check. If it still fails, see Troubleshooting - Connection.
- Make sure the film roll is installed on the film spindle and threaded correctly.
- Set the canvas width in ZRIP: 0.295m for 11.8-inch film, or 0.38m for 15-inch film, then click Confirm.
- In ZRIP, click New to create a blank canvas, or Import to load a test graphic.
- Adjust the image size and layout with the bottom and side toolbars.
- Click Print: choose the correct canvas width, set connection mode to TCPIP, pick a print mode based on your speed and resolution needs, then start printing.
- Watch the progress under Settings > Print or on the printer touchscreen.
- The printed image should be sharp with solid white ink coverage.
- If colors look faded, increase temperature or press time in the curing step (see below).
- If the image is blurry or has streaks, repeat Step 1 before printing again.
¶ Step 5: Cure, Powder and Press a Test Transfer
- Apply hot-melt powder to the printed film and shake off the excess.
- Cure the film at 110-130C for 2-4 minutes (adjust for your film brand; always run a small test first).
- Press the transfer onto a test garment with the recommended temperature, pressure and time for your fabric.
- Peel according to the film type (warm peel or cold peel).