A white mist or haze appears around the edges of your printed design, spreading past the outline of the white underbase. The design itself prints correctly, but the film shows a fuzzy white spray outside the graphic.
White overspray happens when white ink is laid down outside the print area. Work through these checks in order - the first two cover most cases:
- How to check: White ink density is set at 100% or higher, or the white is printed in one heavy pass.
- How to fix: Lower the white ink density to around 80% in your RIP software. If you need more opacity, print the white in two thinner passes instead of one thick pass - you keep the coverage without pushing ink past the edges.
- How to check: The white haze hugs the outline of your design closely, like a halo. This happens when background removal leaves a 1-2 px semi-transparent fringe - the RIP reads it as a print area and lays white under it.
- How to fix: In your design software, contract the selection by 1-2 px when removing the background. In the RIP, enable Remove Transparent Pixels (threshold around 144) or set the white choke to 1-2 px so the white pulls slightly inside the color edge.
- How to check: The mist is scattered randomly rather than following the design, and it gets worse on dry days or in winter. Room humidity below 40% is a strong clue.
- How to fix: Make sure the printer is grounded, install an anti-static bar, and keep shop humidity at 50-60% (a humidifier works). Lowering suction and print speed also reduces static buildup.
- How to check: The nozzle check shows missing or scattered dots, or the white ink has been sitting without being shaken.
- How to fix: Clean the printhead and run a nozzle check. Always shake white ink thoroughly before a print session; if you print daily, add a white ink circulation/stirring system.
- Shake or stir white ink before every session
- Keep white ink density at 80% or below
- Clean artwork edges before saving - no semi-transparent fringe
- Keep humidity above 40-50% and the printer grounded
- Run a nozzle check at the start of every session
- Issue appears only on some designs - it is the artwork (check #2).
- Issue appears on every print - it is ink settings or environment (check #1 or #3).
- Contact support with a photo of the printed film and a screenshot of your RIP white ink settings.