A: For perfect transfers that last, three things are important:
1. A firm, even surface. Iron boards and plastic tables can not provide a firm, even surface needed for successful transfers. We suggest you can use our silicone mat.
2. Use the recommended settings for the iron-on and base material you're using.
3. Make sure you apply firm pressure when transfer.
A: Some applications call for "gentle" pressure, and some call for "firm" pressure. Firm pressure means press down with two hands and 15-40 lbs of body weight. Gentle pressure means one hand with 5-15lbs of body weight. In all cases, a waist-high table is recommended for ease in applying the recommended pressure.
A: Reason comes from three aspects, the pressure is too low, the temperature is not hot enough or the design has not been pressed for enough time. You may need to try more to get right temp, time and pressure.
A: The most common reasons for your images not sticking:
1. Press machine did not make full contact with the base material. This could be because of seams,zippers or anything else that will cause you to not have a flat surface.
2. Verify that your Press machine is set to the recommended settings.
3. Be sure heat has been applied to both the front and the back of the design for the recommended time.
4. Re-touch the front and back of material with heat for an additional 10-15 seconds.
A: Press temperature may fluctuate briefly when placed on the base material after heating. This is due to the difference in temperature of the heated plate and the base material.Don't worry, the Machine temperature will quickly return to the selected setting.Your image adhesion will not be affected.
A: This is the auto-shut off safety feature of Heat Press Machine. After 10 minutes of inactivity, or no button pushes, the device will alert you and then shut off.